You could, however, just as easily swap the polarities of each terminal and accomplish the same thing. The most common reason why you would want to use this setting is when you have an ‘inverted’ subwoofer*. The job of the phase setting is to do one thing: change the polarity/direction of the sub(s) being ran off the amp. What does “Slave” do? Stay tuned for the explanation on “Strapping”. Stay tuned for a future article on how this is done, But for this explanation we are assuming ONE amplifier one, so this switch must stay on MASTER. The Master/Slave Switch is ONLY ever used when “Strapping” the amp with another identical-twin amp (i.e. Moreover, this article will cover each setting Right to Left – use the picture below to follow along – ending at the Gain, which is easily the most important setting of them all. ![]() The names might be a bit different, but they do the exact same thing, more on that later. ![]() Onboard, it has the most common settings found throughout the market. ![]() This article will break down exactly what each common setting on an amplifier does and how to properly tune those settings.įor this example we are going to use the DC Audio 7.5k as an example. The most common misconception of tuning an amplifier is that the settings are intended to ‘give you the most power output’, this is not the case. In order to get the absolute best performance & sound quality from your amplifier it is very important to know exactly how to properly tune an amplifier.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |